в корень карты кладешь файл logcfg.txt
мой файл. долго не мог понять, как логировать 2х байтовое количество воздуха, в итоге таки победил :)
Цитата
; sample logging configuration file for openport 2.0
; must be named logcfg.txt and be placed in the root directory of the
; microSD card inserted in the openport in order to work
; this sample logs using the MUT-II protocol over the K-line, which works
; for many mitsubishis, including the EVO 8 and 9
;----------------mut2----------------
type=mut2
; you can also set an OBD pin to a voltage, ground, or a high impedance state
; the first number is the OBD pin number, the second number is the pin voltage with the following values:
;
; 8000-18000 : voltage in millivolts for OP2 Rev C and earlier
; 5000-25000 : voltage in millivolts for OP2 Rev D and later
; -1 : set pin to high impedance (default state)
; -2 : pull pin to ground
;
; keep in mind that if you are applying a non-zero voltage to more than one pin, all of those voltages
; must be the same
; the following setpinvoltage sets OBD pin 1 to ground, which is needed to enable logging on older Mitsubishis
; it is commented out as it is not needed for newer models (e.g. EVO 8/9)
;
; setpinvoltage=1,-2
paramname=TPS
paramid=0x17
scalingrpn=x,0.39215686,*
paramname=RPM
paramid=0x21
scalingrpn=x,31.25,*
paramname=LOAD
paramid=0x41
scalingrpn=x,1.2,*
paramname=TIMING
paramid=0x06
scalingrpn=x,20,-
paramname=AFR
paramid=0x3C
scalingrpn=x,0.0392156863,*,9.6,+
paramname=BOOST
paramid=0x38
scalingrpn=x,0.016134,*,0.9928,-,0.0345,+
paramname=KNOCKS
paramid=0x26
paramname=KNOCKVolt
paramid=0x30
scalingrpn=x,0.0195,*
paramname=AIRFLOW
paramid=0x00
databits=16
scalingrpn=x,0.0236,*
paramname=WGDC
paramid=0x86
scalingrpn=x,0.5,*
paramname=SPEED
paramid=0x2F
scalingrpn=x,2,*
paramname=MAT
paramid=0x87
scalingrpn=x,-0.4185,*,102.67,+
paramname=MAFAT
paramid=0x3A
scalingrpn=x,1.8,*,32,+
paramname=LTFTLow
paramid=0x0C
scalingrpn=x,0.1953125,*,25,-
paramname=LTFTMid
paramid=0x0D
scalingrpn=x,0.1953125,*,25,-
paramname=LTFTInUse
paramid=0x50
scalingrpn=x,0.1953125,*,25,-
paramname=STFT
paramid=0x0F
scalingrpn=x,0.1953125,*,25,-