Всем привет!

Прочу помочь с подключением буста HKS EVC 6.
Машина EVO 8/
Эл.питание подключил, не могу разобраться к каким разъемам ECU подключать остальные провода :cry:

(１)Pull the white connector of the Extension Harness from the engine compartment into
the vehicle interior and connect it to the 5 PIN connector of the EVC Main Harness. Это понятно
(２)Connect the Extension Harness to the 5 PIN Connector of the EVC Stepping Motor. Это понятно
(３)Connect the EVC Main Harness to the 3 PIN Connector of the Display Unit. Это понятно
(４)Connect the red wire of the Power Harness to the ignition wire using a splice. Это понятно
（ａ）Reconnect the negative battery cable to the battery terminal.
（ｂ）Turn the ignition switch on and find the wire generating 12v using a test light.
（ｃ）Remove the negative battery cable from the terminal of the battery.


Вот это пункт ввел в полный ступор, какой провод куда подключать :(
(５)Confirm the locations of the throttle signal line and the engine RPM signal line or
the speed signal line of the vehicle's harness that connects to the ECU. Connect
the blue wire of the Input Signal Harness to the throttle signal line, and the white
wire to the engine RPM signal line or the speed signal line using splices. Refer to
the factory service manual for signal line locations.　
Advice
・If a speed limiter release device such as the HKS SLD is already installed on
the vehicle, connect the white wire of the input signal harness to the side towards
the vehicle's harness from the device.
・Do not connect unused signal lines.

(６)Connect each input signal wire to the same colored wires on the Main Harness.
(７)Connect the ground wire (Black).

　 Advice
　　・Rub off any paint and/or rust of the surface where the ground wire is connected.
(８)Connect the 4 PIN Connector of the Main Harness to the Power Harness.

　　Note
・When utilizing an external switch for the Scramble Boost activation, connect the
two wires (blue and white) of the scramble harness to a momentary switch in the
form that when the switch is triggered a closed-circuit is made.
Если правильно понял эти провода использутся при подключении какого-то дополнительного прибора ???